Tricks of the Trade — Mini-Dredge Clears Silt Quickly from Boat Channel

เครื่องขุดลอกขนาดเล็กกำจัดตะกอนออกจากร่องน้ำสำหรับเรือได้อย่างรวดเร็ว

The Mud Cat, a two-man-operated mini-dredge recently removed accumulated silt from a lagoon channel at Ventura Keys, Calif. in a test demonstration. Powered by a 175-hp diesel, the dredge operates through an auger assembly at the end of a boom lowered from the bow of the dredge barge. It dredges to a 10 -1/2 foot depth below the water surface. From the stern an 8-inch discharge pipe extended 3,445 feet to a disposal area.

Of this length, 800 feet was a floating line supported by attached flotation tubes. Another 700 feet was threaded by scuba divers through a 66-inch storm sewer. Another section went under Highway 101 through a 36-inch culvert on the way to the discharge end. The dredge was secured by anchor cables placed 250 feet apart and fastened to pilings on one side of the 100-foot-wide channel, and to screw anchors set in the ground on the opposite side of the waterway. At high tide the water is 10-1/2 feet deep.

การทดสอบสาธิต
In this initial operation, in a 400-foot channel section where as much as 4 feet of silt had piled up, the Mud Cat had an average pumping rate of 1,300 gallons/minute, or 82 cubic yards of silt per hour. Solids averaged 20 percent by dry weight.

In 26 hours of pumping, city officials calculated the dredge had removed over 2,000 cubic yards of silt. To reach a more distant spoil area, the dredge used a booster pump which increased its production to 100 cubic yards per hour.

The dredge barge is 30 feet long, has an 8-foot beam, and weighs about 8 tons. It can operate in as shallow a depth as 27 inches. The unit is transported over the highways on its own flat-bed launching trailer.

Reprinted from Contractors and Engineers

ต้องการข้อมูลเพิ่มเติมเกี่ยวกับเรื่องนี้ หรือต้องการพูดคุยกับตัวแทนของ Mud Cat เกี่ยวกับโครงการขุดลอกของคุณหรือไม่?

กระทู้ที่เกี่ยวข้อง

เรือขุดไฟฟ้าลำใหม่ของ PADCOM

รีวิวเรือ | เรือขุดไฟฟ้าแบบสั่งทำพิเศษสำหรับบริษัทเหมืองแร่โพแทสในแคนาดา

เรือขุดแบบมีคนควบคุมนี้ถูกสร้างขึ้นเพื่อตัดผลึกโพแทสในอุณหภูมิที่ต่ำถึง -45°C โดยเข้ามาแทนที่ปั๊มที่ติดตั้งบนเรือบรรทุกในเหมืองโพแทสแห่งเดียวของแมนิโทบา และยังสามารถบรรทุกบนรถบรรทุกคันเดียวได้

อ่างน้ำเกลือโพแทสที่บุด้วย HDPE ของ PADCOM ในรัฐแมนิโทบา ประเทศแคนาดา

บริษัท Ellicott Dredge Enterprises ส่งมอบและติดตั้งระบบขุดลอกแร่โพแทสไฟฟ้า Mud Cat® 30EC แบบสั่งทำพิเศษสำหรับ PADCOM

เครื่องแยกแร่โพแทสเซียมด้วยไฟฟ้าแบบสั่งทำพิเศษ รุ่น Mud Cat 30E ได้รับการพัฒนาโดยทีมวิศวกรรมของ EDE ร่วมกับลูกค้า เพื่อให้ได้อัตราการไหลและความหนาแน่นของโพแทสเซียมตามที่ต้องการ

เครื่องขุดลอกไฟฟ้าควบคุมระยะไกล Mud Cat MC 40E

เรือขุดลอกไฟฟ้า Mud Cat MC 40E เริ่มใช้งานในสาธารณรัฐประชาธิปไตยคองโก

เมื่อสัปดาห์ที่แล้ว ร็อบ คารูเฟล ช่างเทคนิคภาคสนามอาวุโส ได้ทำการทดสอบใช้งานเครื่องขุดลอกไฟฟ้าควบคุมระยะไกลรุ่น Mud Cat MC 40E ของบริษัท Ellicott Dredge Enterprises LLC ที่เหมืองแห่งหนึ่งในสาธารณรัฐประชาธิปไตยคองโก (DRC)

โลโก้บริษัท Ellicott Dredge Enterprises

กุมภาพันธ์ 22-25, 2026

Salt Lake City, ยูทาห์

พบกับเราได้ที่บูธหมายเลข 2937

โลโก้บริษัท Ellicott Dredge Enterprises

มีนาคม 3-7, 2026

ลาสเวกัส, เนวาดา

ใช้รหัส: ELL5455C

ติดตามเราได้ที่
บูธ C22319 (ห้องโถงกลาง)